ND-54 Tube End Notcher is used for cutting and dimpling the branched tube ends to enable the best possible flow characteristics. The ND-54 is a natural complement to the T-DRILL tee forming system. It cuts a half-moon shaped coupon from each side of the branch tube to provide for full flow and simultaneously presses in a dimple that rests on the rim of the tee and acts as a depth stop. A second dimple 6 mm higher acts as a point of inspection. The result is an inspectable brazed joint with the best possible flow characteristics. For branch tube sizes 12, 14-16, 18, 22, 28, 35, 42 and 54 mm and for corresponding inch sizes: ½, ¾, 1, 1 ¼, 1 ½, 2 inch. SPECIAL ORDER Branch Puller / Branch Pulling Device

Read more less